No frustration. Just wanted to have a post to quote instead of typing the same thing over and over trying to explain it when helping people.
Trust me I've had alot, I basically said, here's the info, do it at your own risk, i'm not responsible
I just restore backup nand then it cant boot into OFW and CFW. Im on 5.1 and backup nand is 5.1 too, my burnt fuse count is 6. Anyone can help?
Last edited by kenshinchai,
power off console, manually re-enter RCM with jig and holding button, send hekate, renable autorcm, boot CFW. You can't boot normally with a fuse mismatch and when you restored you lost autorcm
I boot CFW it comes out this error
which cfw are you trying and are you sure you restored the boot files?
Try restoring the backup again, if it fails again you backup was borked, if you don't have another good one backup then you need to manual downgrade
how to manual downgrade? I just restored my backup, never do a upgrade/downgrade.
after re-restoing your boot files does it boot cfw? yes or no, if no look on the sdsetup guide, read it properly and then follow instructions
Are you retarded?
Can you read?
Is the largest word you use regularly above six letters?
If the answer to any of these questions is no, get mommy to help you when hacking a console.
Can you read?
Is the largest word you use regularly above six letters?
If the answer to any of these questions is no, get mommy to help you when hacking a console.
still the same, cant boot CFW, yes I did follow instructions
--------------------- MERGED ---------------------------
im stucked om dumping keys
--------------------- MERGED ---------------------------
Sorry my bad.
still the same, cant boot CFW, yes I did follow instructions
--------------------- MERGED ---------------------------
im stucked om dumping keys
--------------------- MERGED ---------------------------
Sorry my bad.
you have no other backups and the keys weren't previously dumped??
I can't even help unless you have the biskeys
Sorry to jump on this post but-
My switch is on firmware 2. I’m going to be putting CFW on etc. Is it safe to then use Choi to update it to 7.0 or will this mess up the switch similar to downgrading does?
My switch is on firmware 2. I’m going to be putting CFW on etc. Is it safe to then use Choi to update it to 7.0 or will this mess up the switch similar to downgrading does?
While it is safe, you'll burn some precious fuses. What you want is installing autoRCM, then and only then updating with Choi.
Just follow this guide carefully: https://guide.sdsetup.com/
Mhm i noticed that too, but can someone pls enlighten me WHY people are downgrading at all? I mean i totally see why you want to use RCM, preserve your fuses so you can downgrade to an exploitable FW once there gets an cooldboot exploit or smth else interessting released, but there´s nothing out yet.
What´s the reason, the urge, to downgrade? Is there any reason at all to use a lower FW with RCM and hekate when your fuses are already burnt?
Similar threads
