Head to the tutorial section and update without burning efuses. Then you can downgrade later if a better solution comes for 3.0Hello, I'll buy SxPro, and I am on 3.0.0 which means I have homebrew without any jigs.
Should I update to latest firmware or should I stay on 3.0.0 (with the SxPro) ?
Head to the tutorial section and update without burning efuses. Then you can downgrade later if a better solution comes for 3.0
How can you update normally without burning the fuses? I don't think that's how the TX works, the just disabled the fuse check, if you update you still burn fusescan't he just update normally through Nintendo? And then use the tutorial if he wants to downgrade? why do you need to update without burning efuses when you can just update the system normally without burning them?
I mean update your console to 5.1.0 through the eshop and then plug the sx pro in after.How can you update normally without burning the fuses? I don't think that's how the TX works, the just disabled the fuse check, if you update you still burn fuses
Then your efuses are burntI mean update his console from 3.0.0 to latest before putting in the sx pro?
I mean update your console to 5.1.0 through the eshop and then plug the sx pro in after.
the sx pro supports 5.1.0 does it not?
I wouldn't be going online with any modification if you don't want to be banned.Will Nintendo ban for having more e-fuses than required for firmware? Is it safe to keep e-fuses unburnt?
Need someone to confirm but the patch was because when you booted in it auto burnt if you'd upgraded the other way. Doing an update via Nintendo or gamecard will still burn fusesI'm in the same boat except im on 2.3.0.
Apparently since 1.1 SX OS (I'm on 1.2) TX said they patched out the part that burns the fuses so can I do a nand dump before and should be able to restore back after updating in cfw mode ?
there is not reason to stay on 3.0.0 xecuter works on latest firmware,you dont need to wait for anything else all games are supported.Hello, I'll buy SxPro, and I am on 3.0.0 which means I have homebrew without any jigs.
Should I update to latest firmware or should I stay on 3.0.0 (with the SxPro) ?
Seriously? If you have to ask again, update.So can someone answer me ? i don't have any access to a usb-c cable rn, or any rig so ://
Thank youthere is not reason to stay on 3.0.0 xecuter works on latest firmware,you dont need to wait for anything else all games are supported.
How can you update normally without burning the fuses? I don't think that's how the TX works, the just disabled the fuse check, if you update you still burn fuses
So it never boots back into OFW. Didn't think of that. Nice.Having the jig in the right joy-con rail and keeping pressed the vol+ during the update process to make the console enter to rcm after the update then install autorcm and launch the cfw.