@hundshamer Similar to the above question, could you divulge what to search for? for Micro JST connector pairs? Is there a size I should add to my search terms? (I think most say 1.25mm or something) Are they commonly sold with male/female bits together or do you have to buy the females separate?
I'm kinda fed up with microusb. I did the mod, got it working. did a test read and then wrote my original dump (just out of the box) to it. Then I went to disconnect and my glue job on the female bit wasnt good enough... tried being gentle and the male was stuck pretty good in the female, so I pulled harder... and out came the port.
Redid it, this time with routed wires, and while soldering to the musb pins was easier this time, the mod isn't working. I'm guessing I need a smaller wire or something to avoid bridges, but as it is it's just really frustrating, and I'd like to give what you use a shot.
my SD adapter is covered in hotglue too, but I'm sure I can heat it enough to get it off.
But when I go to search for micro JST 4pin, lots of other results come up. Some I'm not sure if they come with 10 males and 10 females or if the female is just pictured to show what the thing connects to.
So knowing what you searched for would be nice.
I'd just send this to you, but I already invested in an iron, tips, solder, wire cutters, flux pens, etc. It'd be a real waste to have someone else do it at this point.