- Joined
- Sep 13, 2022
- Messages
- 7,510
- Trophies
- 3
- Location
- The Wired
- Website
- m4x1mumrez87.neocities.org
- XP
- 21,322
- Country
Oh, maybe a mobile phone repair store might help you out.I meant like a place that would install it for me :/
Oh, maybe a mobile phone repair store might help you out.I meant like a place that would install it for me :/
is that point?Yes, it’s an alternative point nearby the speaker and the triangular ground point.
Nice work.Hi Guys. I'm attaching my first Picofly Tiny mod to switch Oled, expose the DATO point using the Kamikaze method.
The tool used for drilling is MaAnt D1
I put the mosfet on the back of the motherboard.
I also put the SDA and SCL wires for a more stable glitch.
Everything went well without any particular problems. You just need to be careful and be sure of your hand.
I've done the OLED install using the dat0 adapter 3 times so far. All 3 times worked, BUT my first was very close to failure. Soldering skill is not enough, it requires micro-soldering using a scope. Be sure careful.What is the best method for installing the RP2040 tiny? I don’t think I’m experienced enough or comfortable with doing the kamikaze method, so I’m just wondering if there’s anyway to solder directly to the solder points on the motherboard. Also, what is the chance of me breaking my switch by doing this?
Yes it isis that point?
Now i can mod oled without taking the mainboard off the chassis using kamikaze method. Thank you.Yes it is
Now i can mod oled without taking the mainboard off the chassis using kamikaze method. Thank you.
Anyone know error 2002-3540 not working OFW only emunand
cmd resistor? thanks for the reply.wrong resistors as usual.
cmd resistor? thanks for the reply.
yesApu has both sp1 and sp2 cap pads ripped off. Does anyone know if abal1000x alternate soldering location for the mosfet will work without these caps in place? Thanks!
You can use the "normal" point on the CPU, it works even without the caps, you just need to solder the flex to the caps points even without the capacitor (if you are using the flex), the flex that I used had solder points on both sides, so it was relatively easy to solder even without the capacitor.Thank you deeps.
Thanks for the reply but the pads are completely ripped off. This switch that came has all shorts of vandalism.You can use the "normal" point on the CPU, it works even without the caps, you just need to solder the flex to the caps points even without the capacitor (if you are using the flex), the flex that I used had solder points on both sides, so it was relatively easy to solder even without the capacitor.
The sthetix youtube video on the kamikaze method suggests using some flux in the area while drilling to 'catch' the copper dust.Just be sure to clean the grinded copper dust properly and isolate any small connectors like the sd/cartrige pcb and the lcd display with some tapes.
Happened to me once and shorted a connection on the lcd display connector after playing for awhile, suddenly the touch screen is not working anymore. So i had to open again and clean it. Got me confused initially as to what's causing the problem even changed some components and not working. Then upon inspection i checked the lcd connector and it has grinded copper dust inside.
I did but there are instances that during brushing and cleaning some of the bits fly off, so yea an extra safety measure doesn't hurt.The sthetix youtube video on the kamikaze method suggests using some flux in the area while drilling to 'catch' the copper dust.
Do you know the reason why Sometime the mod works with 47 and sometimes with 100 ohm??wrong resistors as usual.