After a long drought in any new Xbox 360 mod hardware, a proper hybrid programmer from Element18592 is out now. Claiming support for all Xbox 360 consoles, this is a swiss army knife for any enthusiast. Supporting all NAND sizes natively and read/write speeds up to 3x it's ancestor, the NAND-X, along with the bonus of having the ability to flash glitch chips for tuning your RGH on the same board. It's not changing the state of homebrew on the system - but it makes improvements for a one time hack or a shop owner that's a nice proposal for anyone diving into Xbox 360 homebrew 15 years later.​

​

The Xflasher 360 is THE FIRST all-in-one Xbox 360 Nand reading/writing and glitch chip programming device.

It can read small block and big block phats, Trinity and Corona 16mb nands, AND the 4gb nands on some Corona consoles!​

It works natively with Jrunner and is a drop-in replacement for any tutorial you're following that uses a JR-Programmer or a Nand-X.​

Features:​

-Twice as fast as the NAND-X
-An all in one design compatible with every Xbox 360 motherboard
-Easily toggle between SPI and eMMC mode with the flip of a switch
-Reads/writes 4GB NANDs in 5 seconds
-Reads/writes 16MB NANDs in under 50 seconds
-No more single use 4GB QSB's
-Native integration with the J-Runner with Extras software
-Flashing compatibility for all Xilinx based glitch chips including the Ace V3, Coolrunner, Matrix, etc
-Native Windows x64 drivers, no more hassling with unsigned drivers​

You can purchase the xFlasher 360 from resellers from The Mod Shop https://themodshop.co/shop/xflasher​

​

 

[Blasingame]

Had my hopes up that this would woork with a winchester Xbox 360 Slim-E version.

 

[Deleted member 668561]

yeah rgh doesn't work at all with winchester it was patched in that rev. I'm sure the one's security measures were copied over too making it impossible to crack

Winchester boards require a CPU swap, with a factory zero efuse CPU, in which case you don't even need rgh, using a glitch2m nand

Nothing from the xbone was copied, they just set some extra efuses before leaving the factory, and added some extra logic on CPU rst iirc

Has nothing to do with the nand, it's how they configure the CPU die internally, is what matters


Technically speaking you should be able to jtag a slim, though it would require alot of porting, if you CPU swap

 

[Octal450]

Many of you are just MISSING the point. This is an All-In-One NAND tool. Nowhere noplace does he say it is to enable homebrew/unsigned code. It is simple used to read or program the flash on the motherboard.

Had my hopes up that this would woork with a winchester Xbox 360 Slim-E version.

It does. As a NAND programmer... because its a NAND programmer and not a glitcher....

Technically speaking you should be able to jtag a slim, though it would require alot of porting, if you CPU swap

No, there was never an exploitable bootloader for slim. You can't use a older one because they lack proper drivers for the XCGPU.

Kind Regards,
Josh

 

[Aheago]

Many of you are just MISSING the point. This is an All-In-One NAND tool. Nowhere noplace does he say it is to enable homebrew/unsigned code. It is simple used to read or program the flash on the motherboard.

Welcome to gbatemp where contributions and releases don’t matter and members only really care about things that will help them pirate. Everything else is “useless”

 

[Luz Noceda]

View attachment 270628
​

After a long drought in any new Xbox 360 mod hardware, a proper hybrid programmer from Element18592 is out now. Claiming support for all Xbox 360 consoles, this is a swiss army knife for any enthusiast. Supporting all NAND sizes natively and read/write speeds up to 3x it's ancestor, the NAND-X, along with the bonus of having the ability to flash glitch chips for tuning your RGH on the same board. It's not changing the state of homebrew on the system - but it makes improvements for a one time hack or a shop owner that's a nice proposal for anyone diving into Xbox 360 homebrew 15 years later.​

​

​

You can purchase the xFlasher 360 from resellers from The Mod Shop https://themodshop.co/shop/xflasher​

​

Question what is the best 360 You can have in terms of hacking and Modding??? The 2013 360???

 

[Ryccardo]

Question what is the best 360 You can have in terms of hacking and Modding???

Top tier would be any model with a new (blank otp) processor, which is what was mentioned earlier as the only option for winchester - as they can boot cfw directly and cleanly, of course they are a luxury more than any practical thing you can buy

Then come jtag systems, which are effectively self-booting - however this is still "from a hacking perspective" only, as jtag requires a very old system version, implying that not only you need a console that wasn't updated since 2008 but also a console that was made back then, and is therefore inefficient and at increased risk of failure

Third in convenience, but a clear first in commercial availability (surprisingly, even as of today - try finding a good DS flashcard instead and...), come all the RGH variants, which can be done to any 360 [with hdmi chipset = not xenon] && not winchester!

Yes, a trinity (early slim) or kronos = jasper 2 (very late fat) are ideal in terms of power efficiency balanced with ease of modding, but only implementation details differ between the various RGH compatible systems!

 

[Deleted member 668561]

Many of you are just MISSING the point. This is an All-In-One NAND tool. Nowhere noplace does he say it is to enable homebrew/unsigned code. It is simple used to read or program the flash on the motherboard.


It does. As a NAND programmer... because its a NAND programmer and not a glitcher....


No, there was never an exploitable bootloader for slim. You can't use a older one because they lack proper drivers for the XCGPU.

Kind Regards,
Josh

if you can run xell, you can run custom bootloaders, 1bl has not changed, so unless there is a physical change within the die, you should be able to modify an older boot loader to run long enough to perform smc expoit, and we do know what your cpu key is, and all ldv are zero

from a technical standpoint if you are able to patch the older 4532 bootloader, and have it run long enough, you should be able to do smc, i would assume drivers would be in the kernel as 2bl (cb, jtag is an exploit within the hypervisor, which resides in 2bl) iirc sets up and inits the hardware and encryption and loads the hypervisor then decrypts and loads cd/cf/ce which would make sense to init video drivers there as you have your security fully set up, normally

or simply burn a valid 4532 fuseset
it would be a fun poc to try

but with a cpu swap unit, are technically the closet to "soft moddable" 360s you will ever get, in the since you can just flash your nand with a glitch2m based image, and once can simply emulate efuses and using a valid dump/kv for online

or just get a devkit

or dump the old hypervisor from 2bl and patch it in the newer bootloader

 

[Octal450]

0 fused CPUs which are not a valid CPU key, can't be used for image creation, and have different rules for what you can and cannot do.

If you have a 0 fused CPU, just launch freeboot directly. No reason to do JTAG or any other exploit, you are ALLOWED to sign the freeboot with the SB key and launch it! This is what I do on all my 0 fused boxes. Booting freeboot without any exploit.

You cannot run a modified bootloader on any non 0 fused CPU because you would need to glitch it and at that point... just run RGH. Even the 1BL verifies the hash of the 2BL. There is no way around that without glitching. The old bootloaders will not run on the XCGPUs properly and if you change them, they fail the hash check. Remember the Slims are split CB from day 1. Also, the CB LDV will mismatch -> it differs on every board and the Slims are totally different, so you'd have to patch out the fuse check or glitch it...

TLDR: without modification, you can't run that old bootloader on the Slim box and if you modify it, it'll fail the 1BL hash check. So that is why nobody even tried to do it.

Kind Regards,
Josh

 

[Crazywhitie]

View attachment 270628
​

The Xflasher 360 is THE FIRST all-in-one Xbox 360 Nand reading/writing and glitch chip programming device

​

This is a False statement.. The X360 SPIFlasher was the First AIO..

 

[vb_encryption_vb]

I still have my original 3 wire JTAG jasper. This brings back memories!

 

[lisreal2401]

This is a False statement.. The X360 SPIFlasher was the First AIO..

SPI and eMMC flasher - although, if you like, the person that made the thingy is linked in the post if you like

 

[Crazywhitie]

SPI and eMMC flasher - although, if you like, the person that made the thingy is linked in the post if you like

right that’s what the x360 Spi flasher has done for years. It’s spi emmc chip programmer AIO