Wiikey Issues

Discussion in 'Wii - Hacking' started by Jenacis, Aug 4, 2007.

Aug 4, 2007

Wiikey Issues by Jenacis at 2:41 AM (735 Views / 0 Likes) 2 replies

  1. Jenacis
    OP

    Newcomer Jenacis Member

    Joined:
    May 4, 2007
    Messages:
    19
    Location:
    Pittsburgh
    Country:
    United States
    Basically - installed a Wiikey, had to use a dremel to solder it to the chip(I have a cut legs Wii) - it worked fine, I burned a few games for it, including a few gamecube games - they all worked fine... I go to play it, no luck.

    It won't play any burned games (Wii or NGC) and any real, legit games - Wii or NGC.

    I'm sincerely hopin' I don't have a brick on my hands - I barely played it for 15 or so hours (total) when this happened...

    Any ideas/suggestions?
     
  2. boblen

    Newcomer boblen Advanced Member

    Joined:
    May 1, 2006
    Messages:
    86
    Country:
    Australia
    Try runing the Wii Setup Disc again...
     
  3. ziddey

    Member ziddey GBAtemp Advanced Fan

    Joined:
    Jun 23, 2007
    Messages:
    542
    Country:
    United States
    what do you mean "they all worked fine... I go to play it, no luck."

    burned fine?

    so am i reading right that even originals won't play now. if so, that's certainly not good. i'm assuming wiikey setup disc won't load either?

    it's possible you may have bridged the legs possibly? can you check for resistance between the legs?

    if it comes down to it, you can try removing all the legs and see if that helps originals play. you can leave the wiikey intact if you wish, since 3 legs will be chopped.
     

Share This Page