Usb loadergx cant load channels

Discussion in 'Wii - Backup Loaders' started by Pootissqaured, Feb 8, 2016.

  1. Pootissqaured
    OP

    Pootissqaured Newbie

    Newcomer
    3
    0
    Feb 8, 2016
    United States
    Hello all
    I have been using usb loader gx (latest) with no issues, when today, i noticed that everytime i try loading any channel in it (not wii game) it goes back to the menu. I didn't change anything. The channels work fine from the system menu. I am using a wii (not wii u). Any suggestions?
     
  2. Pootissqaured
    OP

    Pootissqaured Newbie

    Newcomer
    3
    0
    Feb 8, 2016
    United States
    Update: i have priiloader loading usbgx on startup. When i go directly from there, this bug occurs. However, when i launch usb loadergx from my system menu (fowarder channel) this bug doesn't occur. Posdible ios issue perhaps?
     
  3. rhester72

    rhester72 GBAtemp Regular

    Member
    147
    41
    Feb 7, 2016
    United States
    Two (different) copies of USB Loader GX, one on real NAND, the other on SD/USB perhaps?

    Rodney
     
  4. GreyWolf

    GreyWolf GBAtemp Psycho!

    Member
    4,148
    803
    Mar 2, 2015
    United States
    How did you install it in Priiloader? If you picked it from the menu it installed the dol from the apps folder. You need to get the .dol version of the forwarder and install it.
     
  5. Pootissqaured
    OP

    Pootissqaured Newbie

    Newcomer
    3
    0
    Feb 8, 2016
    United States
    its not that (everything is all fowarders, priiloader, channel, everything). according to the credits page, when I compared the different methods of launching usb loader gx, the credits page always showed usb loader gx rev1260 using ios 249 (rev 21008) +AHB d2x_v8final_base56
     
  6. GreyWolf

    GreyWolf GBAtemp Psycho!

    Member
    4,148
    803
    Mar 2, 2015
    United States
    If you installed the actual dol in Priiloader and updated you would end up with the old version running at boot and the new one running from the system menu or any time you exit a game with ReturnTo>USB Loader GX enabled.

    Check and make sure that it is in fact showing r1260 when you cold boot. Also, are you using the latest Priiloader (0.81)? The older version didn't support loading installed dols with AHBPROT turned off.