Hacking Unknown pkg1 version HOS version not supported

[C Dale]

Hi all,

I'm trying to setup my switch to dualboot between android and emunand. I'm running into a problem though. I preformed these steps:

1. Backed up existing emunand with NXNandManager
2. Backed up all SD contents to PC
3. Deleted all partitions on card and created a new Fat32 part.
3. Used Hekate to create a 60GB Android partition with the rest going to FAT32 HOS.
4. Restored eumnand to hidden partition using NXNand Manager
5. Copied my files back over to FAT32 partition.

When I launch fusee_primary from Hekate, I get the error message shown below. Any idea's on what could be wrong?

Note: If I simply wipe the card and then restore the emunand with NXNandManager, everything restores just fine, all settings are preserved. If I create that android partition, before or after the restore, that's when the error happens.

 

[petspeed]

Step 3 you need to create both a partition for Android and EmuMMC and format the rest as FAT32. Then you can restore your EmuMMC backup to the EmuMMC partition.

 

[C Dale]

Step 3 you need to create both a partition for Android and EmuMMC and format the rest as FAT32. Then you can restore your EmuMMC backup to the EmuMMC partition.

That might be my problem. NXNandManager doesn't have a way to target a specific partition, at least I can't find a way. The restore settings just shows you the entire disk when you select "restore as a hidden partition," which I've always done. Once that's done, Hekate just see's the hidden partition and the generic fat32 partition as a single partition.

I suppose I could restore it as a file, but I've heard that file-based emunands are inferior in performance.

 

[petspeed]

Hekate can also restore. Just make sure you select EmuMMC so you don't accidentally overwrite SysMMC

 

[Draxzelex]

Hi all,

I'm trying to setup my switch to dualboot between android and emunand. I'm running into a problem though. I preformed these steps:

1. Backed up existing emunand with NXNandManager
2. Backed up all SD contents to PC
3. Deleted all partitions on card and created a new Fat32 part.
3. Used Hekate to create a 60GB Android partition with the rest going to FAT32 HOS.
4. Restored eumnand to hidden partition using NXNand Manager
5. Copied my files back over to FAT32 partition.

When I launch fusee_primary from Hekate, I get the error message shown below. Any idea's on what could be wrong?

Note: If I simply wipe the card and then restore the emunand with NXNandManager, everything restores just fine, all settings are preserved. If I create that android partition, before or after the restore, that's when the error happens.

I recommend following this guide for that purpose.