Troubles about Softchip and USB Loader

Discussion in 'Wii - Backup Loaders' started by hangeltao, Dec 26, 2009.

Dec 26, 2009
  1. hangeltao
    OP

    Newcomer hangeltao Newbie

    Joined:
    Dec 26, 2009
    Messages:
    2
    Country:
    China
    I have installed Softchip R102 wad and R99 dol。 Both of them through an Exception when I press + to Change IOS

    Exception (DSi) Occured.

    Then a lot of hex code appeared。

    I have reinstalled Softchip , CIOSCorp V3.6 and CIOS38 Rev14. But it's no use for it.

    My wii is a Korean Version(3.5K) and hacked to USA Version(4.0U).

    Is there anything I can do to fix it?

    Another problem is about my USB loader.

    My hard drive stops any time when I'm playing games. I've tried Configurable USB Loader and Wiiflow. My hard drive still doesn't work well. Then I checked the USB Cable, and connected both of them to give a power support. But this doesn't work too.
     
  2. Madaboeinie

    Newcomer Madaboeinie Member

    Joined:
    Nov 22, 2007
    Messages:
    21
    Country:
    Netherlands
    I've got the exact same problem with Softchip.
    It works fine with ios 249 but as soon as I change it, it crashes.

    It used to work though. I think it went wrong since i did an update to 4.2. ( with a guide from gbatemp )
    Maybe it was a bad flash or something since my Wii also freezes in it's system menu.

    Did you do something similar hangeltao?

    Good thing i made a backup so tomorrow i'll try to use that and go back to an earlier stage.
     
  3. hangeltao
    OP

    Newcomer hangeltao Newbie

    Joined:
    Dec 26, 2009
    Messages:
    2
    Country:
    China
    I'm sorry that I have left for some days.

    I didn't do anything similar.

    This problem doesn't appear at Softchip R92. When I updated it to R102, it appeared.

    Now I'm using the "Load Required IOS" instead of changing by hand.....
     

Share This Page