This part of mod chip didn't fit, is that bad?

[pigy33]

So I bought the OLED RP2040 from here: https://www.aliexpress.us/item/3256...t_main.11.4b3c1802IH9N74&gatewayAdapt=glo2usa

The guy that did it said the piece in the picture of the chip in the bottom right corner that kinda looks like a small USB hub didn't fit inside so he didn't include it.

So, is that bad? The chip came pre-equipped with auto-RCM so it worked when I received it back from the guy and used an SD card with it but now I don't have auto-RCM on and my OLED Switch only boots payload once in a blue moon and usually will just say failure to write files to Switch.

It works fine once it boots to Hekkate or normally going into the Switch without CFW and was working fine before it turned off.

 

[randy_w]

You mean the usb dongle? That's normal as the micro usb port is too thick to be included in the install, but make sure he gives that dongle back to you in case you need to flash the firmware with USB.

Autorcm? It's only relevant to unpatched v1. Also what sd card are you using?