Hacking SX Lite install issue

[SparkyX1]

Hello all,

I have recently installed a SX Lite on my Switch lite and all is working well aside from the right button on my D-Pad (other three directions work fine). Is anyone familiar if this can be caused by a potentially bent "power" (as referred to by installation manual) ribbon cable, or would it be more likely to be from soldering? I am certainly not new to soldering and I verified the work a few times with macro-photography, but who knows. If anyone else has had this issue please let me know. Thanks!

 

[izy]

could be damaged ribbon cable only way to check is replacing it

if not your shorted it

 

[Modificatorul]

Inspect the cap on the line with blue point in last picture,if is present and not damaged, you can use a wire to connect blue point on top sec mb, to the blue point on main mb .

 

[SparkyX1]

View attachment 226320 View attachment 226321


Inspect the cap on the line with blue point in last picture,if is present and not damaged, you can use a wire to connect blue point on top sec mb, to the blue point on main mb .

I don't see any damage to the cap, unfortunately my multimeter/tester is not the best right now so haven't been able to actually test it (my good one got stolen). I just ordered a new set of ribbon cables I found for cheap and if they don't work, I'll try connecting the test points with some wire. Might be a month or more for shipping though. Thanks!