Can anyone confirm the installation points? Look at the above diagram i posted.
And yes, i still cannot get it to work. The new 0.6.0 firmware diagnostic says i have problem with CPU connections.
-Does the 3V3 point need to be permanent like in the picture or the one cap above where you get 3V3 only when Switch is turned on?
-CPU3 when connected, i think it crashes the SX Core. Disconnected, and it actually does something. When reading the schematics and PCB photos, i see that CPU3 is only for Erista model. I have v2 adapter that has the CPU3(Erista point) connected to ground.
I would imagine that the SX core can see that it's grounded if it's connected, and act according, but is it supposed to? Afterall, everything is about focusing on OLED, especially on spacecraft firmwares.
-I have noticed that the resistor(i have 22R) on DAT0 line actually allows the Switch to boot past Nintendo-logo to OFW. Without it, it always hangs after Nintendo-logo.
-Do i need the SD card at all? Can i confirm that the mod works without SD? There's sdloader.enc and hwfly_toolbox.bin, but i don't know if their required in the troubleshooting.
-Anything else worth mentioning?