I plan on setting up an emuNand at some point in the near future. However, there are a few questions I have that are preventing me from doing so:
1. I don't have a Jig, nor do I have a Credit Card in order to get one. However, I have gathered several house-hold items that should do the trick, such as Paper Clips, a Safety Pin, and even some Bobby Pins. My First Question is: would putting a Bobby Pin on both the tenth (10th) Left Joy-Con Rail Pin and another on a Ground Pin (say, Pin 7?), then connecting them in some way (like either using a Paper Clip in the Middle or tilting them until they touch) work in getting into RCM, or would it damage my Switch beyond repair?
2. I have a Toshiba Laptop with Windows Vista that can only be used in Safe Mode, since it gets stuck in an endless loop at the loading bar screen when starting up normally. However, apparently you need to install Drivers in order to send a Hax Payload to the Switch, and I hear Safe Mode disables the use of Drivers by default. My Next Question is: is there any way to enable these so that I can send the Payload (and if so, how?), or will I have to find some other way to do it?
3. I have an Android Phone with USB OTG capabilities (that's also rooted), but no USB OTG Adapter. I can't order one online (thanks to the aforementioned lack of a Credit Card), and I have been unable to find one in-store. I also don't have any devices with a USB Type-C port. However, I've been able to find USB-A to USB-C adapters in the wild, though I have been hesitant to buy one. My Final Question is: would using a plain-old regular USB-A to Micro-USB cord, putting the USB-C adapter on the USB-A end and plugging it into the Switch, while plugging the Micro-USB end into my OTG-Enabled Android device, work just as well in sending the Payload to my Switch, or does it have to use a specific type of Transfer Cord to do so?
Thank You in advance to anyone who helps to answer my no-doubt annoying questions.