Hello community,
I'm starting to get desperate with my Slim. I'm measuring shorts (0.02 ohms) all along the rail that runs over the coil, see markings. I’ve already removed the SBV, the coil, and the two ceramic resistors. No change — the shorts are still present.
I injected 1.5 volts from the coil and used a thermal camera and applied isopropyl alcohol to see if anything would heat up — nothing. Where does this rail go? What else should I try?
The BLOD happened after the console was unplugged from power while in rest mode.
UART error code: 8081001 Power sequence error
I'm starting to get desperate with my Slim. I'm measuring shorts (0.02 ohms) all along the rail that runs over the coil, see markings. I’ve already removed the SBV, the coil, and the two ceramic resistors. No change — the shorts are still present.
I injected 1.5 volts from the coil and used a thermal camera and applied isopropyl alcohol to see if anything would heat up — nothing. Where does this rail go? What else should I try?
The BLOD happened after the console was unplugged from power while in rest mode.
UART error code: 8081001 Power sequence error
