Hacking Question Problem with fusee gelee explioit

[adrian1441]

Im trying to get custom firmware on my switch and i think im doing everything as it is in guides (using switch homebrew guide) and I cant seem to get it right. What ive done so far:
- I checked that my switch is exploitable (XAJ400228xxxxx, so everywhere it shows as ok)
- Grounded pins 1 with 10 on the right joycon (got the 3d printed thingie so it should be all fine)
- Powered off my switch
- Tried turining it on when grounded with Volume up + power (nothing happens so i understand the bridging is fine)
- downloaded TegraRcmGUI and installed the driver

And here starts my problem, because when i try to plug switch to PC with USB cable the switch just turns on. And guide tells me to go back to accessing RCM. I tried the bridging with tin foil, with clipper and now with 3d printed jigg. Tried both pin 1 and 10 as well as 10 and 9 and my switch always turns on when connected to PC. Theres probably something im missing that the guide doesnt state or that i missunderstood since im not really an expert in any of this. Would love to get some help, thanks

 

[Kafluke]

Plug your switch into your PC. When it turns on shut it down in the menu (leave it plugged in to the pc) then try to get into RCM with the jig

You shouldnt see any display on the switch while in RCM

 

[adrian1441]

fuck me i didnt think about such simple solution... Thanks man, Tegra now says RCM OK. Cheers.