Hardware Only HDMI output after exposing DAT0

[XRed_CubeX]

Hi, yesterday I started exposing DAT0 using the kamikaze method for the first time on a Switch OLED. The point is exposed well, I measured it with a multimeter, and everything works. The problem now is that I haven't installed the chip or anything else yet, but the switch turns on and works, but its screen doesn't show anything. However, if I connect it via HDMI, it does. I don't know what to check for now. I don't know if I'll continue with the mod, probably yes, but I'd like to know if there's a solution to this problem.

 

[juanvlc]

Check your screen connector for bend pins

 

[XRed_CubeX]

Check your screen connector for bend pins

That's right, that was the problem, thanks to your suggestion I solved using a needle and eventually completed the mod successfully. Thank you very much!