Hey guys, I installed my first OLED chip today, instinct v6.
All went well(seemingly), however after backing up NAND & creating emunand the fans now run 100% as soon as we boot out of hekate.
Temps seem low in hekate & DBI. It also happens in both emunand & stock.
Any ideas where to start?
SOLVED- Cleaned flux mess in the 3.3v area & reseated fan connector for good measure
All went well(seemingly), however after backing up NAND & creating emunand the fans now run 100% as soon as we boot out of hekate.
Temps seem low in hekate & DBI. It also happens in both emunand & stock.
Any ideas where to start?
SOLVED- Cleaned flux mess in the 3.3v area & reseated fan connector for good measure
Last edited by typecookie,
