Hello,
Bought switch that don't charge.
Firstly the port was damaged, so I replaced it.
After I replaced the port, there were shorts around M92T36.
After replacing M92T36, the shorts were gone, but I'm not getting "No continuity" on those small resistors as on attached image.
The switch was turning on and displaying low battery.
M92T36 looks like I solder it properly, every connection got solder and no bridges.
Also, when I was trying to connect the screen few times I bend the pins, so will have to solder new ribbon connector
Also waiting for new battery and charging IC.
Battery voltage is 3.3V, maybe the battery is over discharged ?
Any help would be appreciated.
Thanks.
Bought switch that don't charge.
Firstly the port was damaged, so I replaced it.
After I replaced the port, there were shorts around M92T36.
After replacing M92T36, the shorts were gone, but I'm not getting "No continuity" on those small resistors as on attached image.
The switch was turning on and displaying low battery.
M92T36 looks like I solder it properly, every connection got solder and no bridges.
Also, when I was trying to connect the screen few times I bend the pins, so will have to solder new ribbon connector
Also waiting for new battery and charging IC.
Battery voltage is 3.3V, maybe the battery is over discharged ?
Any help would be appreciated.
Thanks.