Nintendo lite error of light loss at chip sx and memory card installation hangs.

[tatsumakita]

Hello everyone!
My NS Lite machine happened to have the following condition yesterday:
- I went to Titafol and suddenly the machine reported an error and asked to reboot. After I press reboot my NS lite can't power on for about 30s. 30 seconds later when I turn it on, the NS hangs with a black screen! I took out the memory card, the machine shows the nintendo logo and goes to the original fw of the device, but if I insert the memory card, it only shows the nintendo logo on the screen and hangs there. As usual if I remove the memory card there will be a screen asking for the boot.dat file or if so, it will be the haketa boot screen.

- I tried removing the machine and see the led on the board does not come on!

- But then I tried 3 other white SD cards with no data inserted in NS Lite and all had the same problem of freezing or hanging with a black screen. And when you put the SD card in the device into OFW and operate bt.

- Hope everyone gives me an idea how I will start checking and fixing.

- Thank you for reading the article and hope everyone understands that my English is poor and I had to use google's translation tool to post.

 

[randy_w]

If it's asking for boot.dat, your chip is a genuine sx lite and it's still running the original firmware. You should probably considering upgrading to latest spacecraft:
https://github.com/hwfly-nx/firmware

 

[tatsumakita]

If it's asking for boot.dat, your chip is a genuine sx lite and it's still running the original firmware. You should probably considering upgrading to latest spacecraft:

no buddy. As mentioned above! My Sw lite will hang when inserting the memory card! When I remove the memory card as usual it shows the boot.dat screen but now when I remove the memory card my device goes straight to OFW.

 

[juanvlc]

If your led does not come on check your 3.3 and ground points