Hacking Need help getting into RCM mode

[HaloBenish]

So now that HBL is on 5.0.2 can someone please help me with the getting into RCM mode part of all this. I have some insulated wire with the insulation removed from the tips but when I put it in the right side of the switch it doesn't stay at all. Also do I connect the first and last pins or do I ground the last pin or do I connect the two last pins?

 

[T-Error]

Just stick one end of the wire into the heatsink at the top of the console and bend it to the right so it gets contact with the heatsink. Then you just have to touch pin 10 with the other end of the wire. You could cut a piece of cardboard that fits in to the joycon slot that should help you get the wire stay at the right position. To start in RCM shut down your switch. Connect pin 10 to ground(the heatsink) hold the volume up button and then just connect the usb cable to the switch. You should hear an usb connect signal from your computer but the screen of the switch stays black. Now your ready to start a payload. For me this was the easiest way to get it working with a cable (now I got a printed jig). In short you have to ground pin 10 to anything thats grounded it could be the rail a screw or pin 1 or 7.