Hacking Messed up in hard mod...

[NJima]

I messed up in hard mod.
I have a N2DS LL and when I was trying to solder a wire to the end of one of the resistors by the NAND, I accidentally removed the resistor and damaged the resistor. Now it won't boot with a strange errcode: 00F800FE 00000000 00000000 00000003 00400000
The photo shows where the pad of the resistor. Can any N2DS XL owner tell me the resistance of the resistor? Thanks.

 

[mitroux]

just use a multimeter to mesure the next resitor to it (all 4 resistors have the same value , probably 100ohm or 1 k

 

[wicksand420]

You should never touch the tip of the iron to the board, you flux the point of the wire and the node on the board, load some solder onto the wire, and touch the wire to the node, and touch the wire slightly with the soldering iron.

 

[NJima]

just use a multimeter to mesure the next resitor to it (all 4 resistors have the same value , probably 100ohm or 1 k

What I measured is about 27.5ohm. Is this normal?

 

[mitroux]

What I measured is about 27.5ohm. Is this normal?

i don't know , but if that's the value you read in ohm , then it should be 27 or 30 ohm
i don't have a 2ndsxl yet..for 3dsxl it was 100 ohm , if you have a 100ohm then try it , it should work