Hacking Just cant get into RCM mode

[SMVB64]

Hey, could you guys look at my RCM jig and see if I have done any thing wrong?
I have sanded this thing down to a T and it looks correct but the Nintendo logo keep popping up.
Im using the right joy-con rail and holding power + when booting

https://imgur.com/SgfydLK
pic1
https://imgur.com/7hqxSB8
pic2
https://i.imgur.com/7OPPQkO.jpg
pic3


(For some reason I wasn't able to embed the photos)
Should there be more contact? I don't know anymore

 

[masterspike52]

I think you shrunk em yoo much

 

[Haztel]

Try this out: Put the jig in, hold the volume up button and without holding down the power button plug it into the PC.

 

[PatrickJr]

Give it a good blow.

 

[Peabutt]

Try it with a safety pin instead of your jig (maybe the prongs on your jig aren't contacting the pins properly). You can short it out on the inside of the joy-con rail.

(stole the picture from another thread)

 

[DocAmes1980]

Do you have a multimeter? Have you checked continuity between the pins?

 

[Taffy]

If you just get a fat paperclip, that'll work too. Make sure it appears to be touching the pins when you use it.

I've only used paperclips when doing this, I can't speak for proper jigs.

 

[Soluble]

Do you have a multimeter? Have you checked continuity between the pins?

This. Looks like it was brutalized.