Hardware I think i bricked my switch while updating my system.

[demistigon]

being an idiot, i updated my switch ofw through settings and the screen went black. I power off switch by pressing power button for 15s but i couldn't turn it back on. since i had autorcm on, I tried to push fusee_primary payload to load into atmosphere but it get stuck in a black screen. I can go to hekate menu through payload but thats it.
did i fried my ofw? I cant seem to turn the system on normally. i have tried taking the mmc out but it didn't work. I dont have a backup.

 

[bell1-1010]

being an idiot, i updated my switch ofw through settings and the screen went black. I power off switch by pressing power button for 15s but i couldn't turn it back on. since i had autorcm on, I tried to push fusee_primary payload to load into atmosphere but it get stuck in a black screen. I can go to hekate menu through payload but thats it.
did i fried my ofw? I cant seem to turn the system on normally. i have tried taking the mmc out but it didn't work. I dont have a backup.

What cfw were you on before updating? Also any chance you could trigger a wrong fuse count?

 

[demistigon]

What cfw were you on before updating? Also any chance you could trigger a wrong fuse count?

i was on atmosphere 0.10.5. the thing i am afraid of is that i cannot load into the ofw. I have tried hekate but there is nothing there.

 

[Paulsar99]

If you're on 10.0.0 firmware then you need the latest atmosphere which is 0.11.1, lower than that and you will get a blackscreen.

 

[demistigon]

Oh, I think i figured out the problem. I removed the sd card 5th time and pressed the power button. and voilà it works and has been updated to 10.0.0. all i have to do is update my atmosphere. Thanks everyone. I had a quiet a terrifying day today.