Hey! just had a quick question about the HWFLY installs.
I just attempted my first one, and when plugging it in, I reset it like in sthetix's video on it using a magnet, the modchip lit blue, and screen turned on normally. I turned it off, and it started training. It trained for 3 hours straight and nothing happened.
I disconnected the battery while it was still training since it wouldn't stop with even holding the power for a while, and checked my points. Found out the data0 point had popped off, along with the pad.
I took the adaptor out and put a new one in, and it read .4 ohms, just like the first one. Tried restarting the switch to blue, and no screen, but the chip shined blue. I even tried assembling it alltogether, and plugging it into the TV, and nothing.
I disassembled it all again, all points are good. I tried taking the data0 adapter out again and this time reflowing with a rework station onto the adapter itself, turned it on, and still nothing on-screen.
The switch modchip can still shine blue and still attempt to train, but it goes forever with yellow pulses, never green, and never ends. I even tried swapping that chip out for another and it still did the same thing.
I looked on the forum and haven't seen any problem like this one, usually if it's a board issue, the screen pops up pink, but all I changed is the emmc data0 point and the issues started from there. Is my emmc chip busted, is there anything you think I can do, or is my switch toast?
Thank you in advance for every and any piece of advice you can give, it's highly, highly appreciated!
I just attempted my first one, and when plugging it in, I reset it like in sthetix's video on it using a magnet, the modchip lit blue, and screen turned on normally. I turned it off, and it started training. It trained for 3 hours straight and nothing happened.
I disconnected the battery while it was still training since it wouldn't stop with even holding the power for a while, and checked my points. Found out the data0 point had popped off, along with the pad.
I took the adaptor out and put a new one in, and it read .4 ohms, just like the first one. Tried restarting the switch to blue, and no screen, but the chip shined blue. I even tried assembling it alltogether, and plugging it into the TV, and nothing.
I disassembled it all again, all points are good. I tried taking the data0 adapter out again and this time reflowing with a rework station onto the adapter itself, turned it on, and still nothing on-screen.
The switch modchip can still shine blue and still attempt to train, but it goes forever with yellow pulses, never green, and never ends. I even tried swapping that chip out for another and it still did the same thing.
I looked on the forum and haven't seen any problem like this one, usually if it's a board issue, the screen pops up pink, but all I changed is the emmc data0 point and the issues started from there. Is my emmc chip busted, is there anything you think I can do, or is my switch toast?
Thank you in advance for every and any piece of advice you can give, it's highly, highly appreciated!