Hacking How to launch priiloader on a emunand?

[Lilpaulo3232]

What the title says. I've tried holding reset as I load it up with Neek2o but had no luck with it whatsoever.

 

[XFlak]

Latest versions of neek2o block priiloader. If u want access you would need to install an older version of neek or neek2o.

I don't recall the specific version # off the top of my head, but if you run modmii's emunand builder, on the screen where it asks about installing priiloader, it will tell you

 

[Lilpaulo3232]

Latest versions of neek2o block priiloader. If u want access you would need to install an older version of neek or neek2o.

I don't recall the specific version # off the top of my head, but if you run modmii's emunand builder, on the screen where it asks about installing priiloader, it will tell you

tried replacing it with version 80 and such and still no luck, maybe I have to go older?

 

[XFlak]

From ModMii:

Note: neek2o rev93-96 will bypass Priiloader if detected on EmuNAND.

Note: to access Priiloader on your emulated NAND, hold reset just as your emulated NAND is booting up or use the Load Priiloader app.

 

[Lilpaulo3232]

From ModMii:

1. Holding Reset would still take me to the warning screen. Idk if there's like a different timing to this or something.

2.Using the load up on the emunand just kicks me back to the home menu

 

[XFlak]

Load your emunand using modmii classic and see if you can remove/re-add priiloader and try again

 

[Lilpaulo3232]

Load your emunand using modmii classic and see if you can remove/re-add priiloader and try again

Is there like a certain time to holding reset? Uninstalled and re installed and it still doesn't work and I'm fresh out of ideas and starting to give up here.

 

[XFlak]

Maybe try the original neek, not neek2o?

Info regarding when to hold reset quoted from modmii above, but I'd think load priiloader should work

 

[Lilpaulo3232]

Maybe try the original neek, not neek2o?

Info regarding when to hold reset quoted from modmii above, but I'd think load priiloader should work

where I can find that?

 

[XFlak]

Enable it in Modmii's options

 

[Lilpaulo3232]

Enable it in Modmii's options

trying to install it now and it's channel forwarder but it just says unable to initialize usb drive, even though it's in the wii. I think this is the end of me getting priiloader to work and making my emunand reigon free

 

[XFlak]

Isn't that baked into neek anyway? Usually people don't care about priiloader on emunands because of that

 

[creedof69]

Isn't that baked into neek anyway? Usually people don't care about priiloader on emunands because of that

Personnaly I care about priiloader to use to autoboot to homebrew channel or something else than system menu, and I fell on this thread