help with finding switch lite alternative 3.5v pin to install hwfly 4

[redditorguy]

hi
please assist trying to solder following with wire skipping the flex cable as had some issues, is there like alternative 3.3.v pin around the board rather than that one as it is very tiny for my wire ?
thanks

 

[juanvlc]

You can always grab it from original hwfly 3.3 and gnd points, on micro SD cap, Lh is 3.3v and Rh is gnd if I remember correctly.
Also you can get AL10064 awg36 from Ali, it's cheap and good for this job.
Best regards

 

[redditorguy]

could you please send a picture of the micro sd cap ? thankjs

 

[juanvlc]

The upper one of the two, the big one

 

[redditorguy]

thanks heaps are these the only two points? looking for bigger one

 

[Jayro]

Soldering a wire to surface-mount components isn't super difficult, as long as you have a steady hand and a sharp tip on your iron. I hold my breath while soldering, so I don't shake, and don't inhale the toxic fumes.

 

[de9ed]

thanks heaps are these the only two points? looking for bigger one

the sd card capacitor is pretty big.