So I just setup RGH on this xbox and I cannot get it to boot into xell. I've never had this issue before. I know it has something to do with the wiring but I cant see what I did wrong. I do NOT get rrod after boot, just no signal.
I have rewired the points at least 4 times. I've tried 1k, 3k and no resistor on the PLL line. I've used magnet wire and kynar wire, I've routed the wires so they are not close to any SMDs and I've made the wire as short as possible. I've also rebuilt the xell image multiple times and I tried to build xell with an older version of jrunner (was an update when I started it yesterday).
If consoles go to MS for repair can they still make them unmoddbale? I thought MS did something like this when we could only JTAG units.
All I can think of right now is to reflash the stock nand and make sure it boots correctly
Any suggestion appreciated.
EDIT: I reflashed the stock nand and it boots normally. I updated the dash to 17559 and redid the mod again. Still no xell
I have rewired the points at least 4 times. I've tried 1k, 3k and no resistor on the PLL line. I've used magnet wire and kynar wire, I've routed the wires so they are not close to any SMDs and I've made the wire as short as possible. I've also rebuilt the xell image multiple times and I tried to build xell with an older version of jrunner (was an update when I started it yesterday).
If consoles go to MS for repair can they still make them unmoddbale? I thought MS did something like this when we could only JTAG units.
All I can think of right now is to reflash the stock nand and make sure it boots correctly
Any suggestion appreciated.
EDIT: I reflashed the stock nand and it boots normally. I updated the dash to 17559 and redid the mod again. Still no xell
Attachments
Last edited by ganjo,
