Hey guys, just registered to ask for a little help. Very fresh to the scene, so bear with my noobie understanding of how things work.
I had the intention of installing cfw on my O3DS XL 11.2 with help from 3ds.guide. I followed each step to the letter, but I ran into trouble when I started the process on the "Installing arm9loaderhax" page. My Sony 32gb(yes, a real one) died on me. Earlier in the process I had already copied all of my files on the card to my desktop. I used a new Sandisk 32gb, copied over all the files I had backed up to this card, and continued with the process. When the time came to do a "Sysnand restore(with a9lh)" it failed. After searching, I came to the conclusion that I needed certain partitions on that old sd card. !I think this is where I mucked up! I searched for options, and I saw some people were advised to update to a higher firmware and try again. I was fine with restarting the process. So I updated with Fire Emblem Awakening to 4.4(I think?) and now I get the message about how "An error has occurred: An old unsupported FIRM has been detected. Copy a firmware.bin in /luma to boot." While I could do some guesswork, I'd rather not. So that is where I am right now.
Just an FYI too, I can boot into Luma and hourglass9 just fine.
Thanks for reading, I truly appreciate any help that you can give.
I had the intention of installing cfw on my O3DS XL 11.2 with help from 3ds.guide. I followed each step to the letter, but I ran into trouble when I started the process on the "Installing arm9loaderhax" page. My Sony 32gb(yes, a real one) died on me. Earlier in the process I had already copied all of my files on the card to my desktop. I used a new Sandisk 32gb, copied over all the files I had backed up to this card, and continued with the process. When the time came to do a "Sysnand restore(with a9lh)" it failed. After searching, I came to the conclusion that I needed certain partitions on that old sd card. !I think this is where I mucked up! I searched for options, and I saw some people were advised to update to a higher firmware and try again. I was fine with restarting the process. So I updated with Fire Emblem Awakening to 4.4(I think?) and now I get the message about how "An error has occurred: An old unsupported FIRM has been detected. Copy a firmware.bin in /luma to boot." While I could do some guesswork, I'd rather not. So that is where I am right now.
Just an FYI too, I can boot into Luma and hourglass9 just fine.
Thanks for reading, I truly appreciate any help that you can give.