Gateway + DSTwo

Discussion in '3DS - Flashcards & Custom Firmwares' started by onepiecefreak, Nov 16, 2015.

  1. onepiecefreak
    OP

    onepiecefreak The Special One

    Member
    391
    133
    Aug 12, 2015
    Germany
    Hey there,

    i want to know if there is a way to combine the gateway emunand (or any other) and the DSTwo Flashcard.
    I have a new3DS on 9.0.0 in sysnand and 9.5.0 in (gateway-)emunand. They're unlinked.
    The reason behind is that I think if I use the DS Flashcard in emunand the DS Profile Exploit won't be deleted in sysnand system settings. That's because I want to run the DS Flashcard in emunand, but the gateway card is blocking the Cardslot, that's why I ask for a kind of combination in that form.

    Thx for any help.

    Greetings.
     
  2. kamesenin888

    kamesenin888 GBAtemp Advanced Fan

    Member
    574
    148
    Oct 20, 2007
    dude there is a way to keep the ds exploit even if you use the ds two in sysnand, in emunand afaik you cannot run ds games
     
  3. gunner007

    gunner007 GBAtemp Advanced Maniac

    Member
    1,506
    368
    Dec 31, 2013
    United States
    There isn't a way - Gateway mode redirects the cartridge reads to the red-card, so legitimate carts/DS carts won't even show.

    Even if you somehow managed to, the TWL firmware doesn't work in either GW modes.

    Best bet is either try to get the exploit to stick, or use a CFW.
     
  4. onepiecefreak
    OP

    onepiecefreak The Special One

    Member
    391
    133
    Aug 12, 2015
    Germany
    Can I run a CFW and the emunand from gateway simultanously on the same SD Card?
     
  5. Traiver

    Traiver GBAtemp Maniac

    Member
    1,199
    1,290
    Aug 1, 2014
    Germany
    Pew! *Out of the bag*
    The first thing is not possible. You can run CFW besides Gateway easily. Your best option is Pasta CFW. My new3DS is set up with both, too. Its because I want to run Virtual GBA games on my new3ds console.
     
    XRaidersP likes this.
  6. onepiecefreak
    OP

    onepiecefreak The Special One

    Member
    391
    133
    Aug 12, 2015
    Germany
    Do you mean you have the CFW on a separate SDCard? I can't figure that out of your comment.
     
  7. Traiver

    Traiver GBAtemp Maniac

    Member
    1,199
    1,290
    Aug 1, 2014
    Germany
    Pew! *Out of the bag*
    No, its on the same SD Card as my Gateway Emunand and some more stuff. If you need help with it, send me a private message.
     
    XRaidersP likes this.
  8. Xenon Hacks

    Xenon Hacks GBAtemp Guru

    Member
    7,115
    3,412
    Nov 13, 2014
    United States
    OR and just hear me out install the bluecard fix stop using MSET and just use homenuhax + Mini Pasta + Cubic Ninja CIA
     
  9. onepiecefreak
    OP

    onepiecefreak The Special One

    Member
    391
    133
    Aug 12, 2015
    Germany
    Is there a nice tutorial to set it up like you mean it Xenon? I can't get it fully. I mean in which I have to do what?
     
  10. kamesenin888

    kamesenin888 GBAtemp Advanced Fan

    Member
    574
    148
    Oct 20, 2007
    dude this worked for another user i tried with mine and it worked fine, its far easier than doing homemenu hax that doesnt always boot this will work with sysnand and you shouldnt have a problem with ds exploit

    this worked for me too! Thanks so much!
    Previously the profile exploit was wiped till I tried this. Below are my actual steps.

    1) Install the exploit using the N3DS_ROPInstaller.nds; e.g. Profile Name: slslasher
    2) Go to settings and change Profile Name to another one; e.g. Profile Name: slslasher01
    3) Launch a DS game, exploit would be gone
    4) Install the exploit using the N3DS_ROPInstaller.nds again and it should be stuck

    Extra Steps because I want to change back my original profile name
    5) Go to settings and change Profile Name to my original one; e.g. Profile Name: slslasher
    6) Launch exploit and test, there should be an error.
    7) Install the exploit using the N3DS_ROPInstaller.nds again and it should be stuck
     
    Quantumcat likes this.
  11. onepiecefreak
    OP

    onepiecefreak The Special One

    Member
    391
    133
    Aug 12, 2015
    Germany
    Where can I find the N3DS_ROPInstaller.nds. I google for that but there isnt a source.
    Or can I use the normal GW bluecard.nds?
     
  12. Quantumcat

    Quantumcat Dead and alive

    Member
    11,576
    6,223
    Nov 23, 2014
    Australia
    Canberra, Australia
    I think you can use whatever ROP you are using anyway. I am on Gateway and did this with the Gateway ROP and it worked fine for me.
     
  13. onepiecefreak
    OP

    onepiecefreak The Special One

    Member
    391
    133
    Aug 12, 2015
    Germany
    Thx, I will try it ASAP.

    Just for the information. What does ROP mean?
     
  14. Quantumcat

    Quantumcat Dead and alive

    Member
    11,576
    6,223
    Nov 23, 2014
    Australia
    Canberra, Australia
    It is the .nds file that installs the DS profile exploit. I don't know what it stands for.
     
  15. hippy dave

    hippy dave Butts Butts Megabutts

    Member
    2,592
    1,805
    Apr 30, 2012
    Quantumcat likes this.
  16. Quantumcat

    Quantumcat Dead and alive

    Member
    11,576
    6,223
    Nov 23, 2014
    Australia
    Canberra, Australia
    ldeveraux likes this.
  17. onepiecefreak
    OP

    onepiecefreak The Special One

    Member
    391
    133
    Aug 12, 2015
    Germany
    Ok, I found time to try it. The way kamesenin described was very right. You can use the normal GW_Installer.nds packed with the official gateway package instead.
    That close the thread. Thx.