Hardware Freshly replaced SD card reader doesn't work again

[KiwiDuuude]

So today, after having a broken sd card reader for almost year I finally ordered a new one. I managed to replace it with only one broken screw lol. It worked fine at first: I was able to boot into Nyx and do a complete NAND backup. After I did that, I decided to restart Hekate, but once it loaded up again, I got a message that the SD card is in 1 bit mode or something. So I opened up the Switch again, pressed a little more onto the connector and closed it up again. Once I restarted, it stopped working. Completely. OFW doesn't see the SD card anymore, neither does Hekate. I tried everything: disconnect the reader, reconnect it again, loosen the screw on the reader so it has a bit more room - nothing works. The pins on both the reader and the board seem to be intact, so I'm really confused as to what is happening. Any help?

 

[BaamAlex]

It's what you read on the pop up.
Your sd card reader is either not properly seated or a pin broke on the motherboard connector because of many ejections/insertions. You can still use CFW and OFW. But the sd performance will be a mere 5MB/s until you repair that.

 

[LyuboA]

better get to a repair shop they can fixed Not Nintendo one of course or a technician that you may know have you checked the pins with magnifying glass and also the traces around the connector on the motherboard