The new board came in, when it arrived I noticed that the ground and positive cables coming from the connector were mixed up, I decided to try it anyway, all it did was make it so the screens turned white, red battery light came on, then it immediately went off. I figured it was doing this because it was getting the power from the battery but because the cables were mixed up the system couldn’t properly utilize the battery. Because of this, I took it upon myself to resolder the cables in the right way, when I did this it stopped working. The device with the new board no longer recognizes the battery, it just sits there and blinks with the orange charging light. As far as I can tell I didn’t damage anything on the board while resoldering the wires, anyone have any ideas what would be causing it to just not react to anything now?