Thank you very much!. i'll complete the definitions file of my Universal Skinning tool.
Is there an offset for the checkbox colors and the
i'll post that in the original thread.
--------------------- MERGED ---------------------------
i got a very similar problem with the first release of the ez flash omega.
the case was made pretty bad and the bga soldering of the fpga did the rest. a very few weeks after usage is starts with errors like
Firmware Update V00 found, etc.
after i disaassambled the case is saw that the pcb was bent a little bit and the FPGA is going to lift off.
i was not able to repair it, so i bought new one about 2 weeks ago.
ezflash made a better case, it is not that much strong in the gameboy.
but that doensn't matter in my case. I made an own housing for the pcb from an original nintendo game. because the original case is not perfect at all.
I cut out holes for the chips in the back from the case so there is no further mechanical force on the chips itself:
View attachment 166483 View attachment 166484 View attachment 166485
the second one i hat i soldered it directly into my gba where the cart slot was defect. i used then another old game housing for holding an standard SD Card and used a Adapter with SD Slot and Micro SD Connector, so it can take default SD cards, too.
View attachment 166488 View attachment 166486 View attachment 166487
kind regards