I'm at a loss.
Everything is plugged in, but the readme makes no sense to me.
Where do the drivers go, and what the hell do I do next? The updater flashes a window for a split second and nothing happens.
Help. > >
Everything is plugged in, but the readme makes no sense to me.
QUOTE said:===============================
d2pro v1.3 update - 15/19 wires
===============================
This software is provided as-is, with no warranties of any kind.
If you use this software, you do so at your own risk!
=======
WARNING
=======
*** Do not update installed chips with diode shorted! ***
The diode prevents current from d2prog from flowing to the d2c chip.
If the diode has been shorted the d2c chipmay be permanently damaged.
There is no need to short the diode. If shorting the diode "solved" any problems
you are most likely using too long and/or too thin wires for 3v3 and GND.
Thank you for using d2pro!
=====
Fixes
=====
- Fixed a media detection bug that caused certain pressed discs not to
load properly
- Fixed a bug that caused the drive to sometimes reset on eject, making it
difficult to eject discs
============
Instructions
============
1. If the d2pro chip is already installed in a Wii console then
disconnect the power cable.
2. Disconnect d2prog from the USB cable.
3. Connect the flat flexible cable to d2prog (and to d2pro if you have
not done so already).
Be VERY CAREFUL when connecting the cable and make sure that is in
place properly. If the cable is misaligned and the Vcc (power) and
ground lines are shorted d2pro or d2prog could be damaged.
4. Connect the USB cable to d2prog.
5. Run the updater software. It can be run without parameters for
fully interactive mode, or with the following switches:
usage: ./d2prog [-v] [-n] [-y] [-f ]
-v verify only
-n flash only, don't verify
-y start flashing immediately
-f select firmware
Run without parameters for fully interactive mode.
-h brings up the help.
6. Disconnect USB cable and then d2prog. (done!)
Where do the drivers go, and what the hell do I do next? The updater flashes a window for a split second and nothing happens.
Help. > >