DS Lite Acekard 2i help

Discussion in 'Acekard' started by vagiclean, Jan 3, 2013.

Jan 3, 2013

DS Lite Acekard 2i help by vagiclean at 11:40 PM (517 Views / 0 Likes) 1 replies

  1. vagiclean
    OP

    Newcomer vagiclean Newbie

    Joined:
    Jan 3, 2013
    Messages:
    1
    Location:
    Wilson, North Carolina
    Country:
    United States
    Sorry im new to the forum but ive been searching all over the internet to try and figure out how to fix the issue. Ive been working on 2 DS's one being a DS and the other being a DS Lite. i ordered a acekard 2i for the and both of the cards work in the original DS but neither of them work in the DS Lite. i tried the paper trick and it didnt work, im still getting no DS Card message on the main screen. I was wondering if there is anything else i can do.
     
  2. Another World

    Former Staff Another World Emulate the Planet!

    Joined:
    Jan 3, 2008
    Messages:
    10,476
    Location:
    From Where???
    Country:
    Colombia
    if the card works on one system, then its not the msd, software, etc. it must be a contact issue. it could be you need to physically move the pcb. you might have a bent pin on the ds lite. the paper trick will only work if the issue is related to raising the contacts. when you attempt it, start out VERY thin and work your way up. i found that really thin cuts of magazine paper or phone book paper worked the best.

    -another world
     

Share This Page