Homebrew decrypt9 not booting

[AquaX101]

Using a9lh with a cia of the homebrew launcher installed, I tried to boot up decrypt 9 but then it just leads me to a red screen then back to the homebrew launcher. Any fix?

 

[VinsCool]

Use the a9lh payload of decrypt9 instead.

 

[AquaX101]

Use the a9lh payload of decrypt9 instead.

what is the file extension of it and where do i put it in my sd?

 

[VinsCool]

what is the file extension of it and where do i put it in my sd?

it's a bin file. if you use LUMA, you can use it by the following:

Payload Chainloading
Allows you to run other ARM9 programs on boot.
How to use:

Put any payload you wish to use in SD:/luma/payloads, and rename it to <button>_<name>.bin(where <name> can be whatever you want)

<button>_<name>.bin can be as follows:

• x_NAME.bin
• y_NAME.bin
• select_NAME.bin
• start_NAME.bin
• r_NAME.bin
• a_NAME.bin
• b_NAME.bin
• right_NAME.bin
• left_NAME.bin
• up_NAME.bin
• down_NAME.bin

For r_NAME.bin, a_NAME.bin and select_NAME.bin you need to press L+R, L+A and L+SELECT on boot respectively.
For any other payload you only need to hold its corresponding button.
If you're using a non-screen-init version of A9LH, it will be done automatically before launching the payload.

so get decryt9, and put it in your sd card using the following. the button must be held during the consile boot to load the payload.