Hey Guys & Gals,
I've searched around with not much luck. I compile my sneek code by using ChokeD's guide. I recently compiled r123 of the source code for UNEEK + DI. All is fine until I load games. I get a lot of freezing when I select a game and try to start a game.
I would like to know if there is a way to compile r121 from source once the source code has been changed.
Using "svn checkout http://sneek.googlecode.com/svn/trunk/ sneek-read-only" obviously checks out the latest source. Is there another command that would check out older revisions?
For now I had to use Sneek Installer with the pre-compiled r121 modules to get back to a stable state, but I like compiling fresh.
Any thoughts or advice.
Thanks In Advance,
Punk-7
I've searched around with not much luck. I compile my sneek code by using ChokeD's guide. I recently compiled r123 of the source code for UNEEK + DI. All is fine until I load games. I get a lot of freezing when I select a game and try to start a game.
I would like to know if there is a way to compile r121 from source once the source code has been changed.
Using "svn checkout http://sneek.googlecode.com/svn/trunk/ sneek-read-only" obviously checks out the latest source. Is there another command that would check out older revisions?
For now I had to use Sneek Installer with the pre-compiled r121 modules to get back to a stable state, but I like compiling fresh.
Any thoughts or advice.
Thanks In Advance,
Punk-7