Required:
1x d-sub connector 25 position Male
1x d-sub Hood
1x ATmega8L
1x 47uF Capacitor, Radial
7x Resistor 220 ohms
2x 28 Pins DIP Socket 0.3In (7.54mm dont confuse this with 0.6In)
1ft any wire between 20awg-30awg
Optional:
1x Resistor 120 ohms
1x 0.1 uF Capacitor (same thing as 100 nF)
1x LED
you can acually use the 0.6in dip socket if you cut the center out, i also used a predrilled board from radioshack to minimize possibility of a short, prob cheaper and easier to use tape or gluegun in the dsub hood
1x d-sub connector 25 position Male
1x d-sub Hood
1x ATmega8L
1x 47uF Capacitor, Radial
7x Resistor 220 ohms
2x 28 Pins DIP Socket 0.3In (7.54mm dont confuse this with 0.6In)
1ft any wire between 20awg-30awg
Optional:
1x Resistor 120 ohms
1x 0.1 uF Capacitor (same thing as 100 nF)
1x LED
you can acually use the 0.6in dip socket if you cut the center out, i also used a predrilled board from radioshack to minimize possibility of a short, prob cheaper and easier to use tape or gluegun in the dsub hood