Hacking Can't install HBC on a DarkCorp'ed wii

matanga

New Member
OP
Newbie
Joined
Jun 10, 2010
Messages
4
Trophies
0
XP
1
Country
Argentina
Hi guys,

I've uninstalled HBC from my wii withous previously uninstalling DarkCorp.

Now I wan't to reinstall HBC to run an USB Loader but I can't run HackMii because I receive "No vulnerable IOS found".

I've found that I have to replace 2 IOS thru Bannerbomb to allow HackMii to run again, but I receive the following "exception (dsi) occurred" while trying to run anything from Bannerbomb.

Any suggestions? Any way to install HBC, uninstall DarkCorp, replace IOS, perform a Nand restore, or do anything to get it resolved? Remember that, at this point, I can't run HackMii because of "No vulnerable IOS found" message.

Thanks in advance.

Matanga!
 

kano

Well-Known Member
Newcomer
Joined
May 19, 2008
Messages
71
Trophies
0
XP
131
Country
Malta
Hi, Im not a l33t haxor but I can give u some of my experience, first of all are you sure you trying to install the right HBC for your system ? there are 2 versions that are for system menu below 4.0 and above 4.1, if u still cant install try update your wii so you will replace any cios with official ios and then folow a guide to rehack your 4.2 wii, beware that you will loose any hacks on your wii doing this so be sure b4 u try. hope Iv been of any help
 

transam81

Well-Known Member
Member
Joined
Oct 4, 2009
Messages
284
Trophies
0
Age
42
Location
Central California
Website
Visit site
XP
81
Country
United States
here are some clips from the darkcorp thread (lazy).

All IOS have their version number maxed out to prevent being
overwritten by an Official Nintendo Wii System Update (although we do
not recommend performing a Wii System Update anyway).

How to uninstall it:
First of all, DON'T DELETE ANY IOS!!! YOU WILL (most likely) KILL
YOUR WII IF YOU DO!!! Rather, the IOS must be OVERWRITTEN with
official, unmodified IOS. Just run the “DARKCORP v1.0 Full Installer”
or the “DARKCORP v1.0 Lite Installer” and select:
Uninstall DARKCORP (YOUR IOS WILL LOSE ALL PATCHES!)
This will replace your cIOS with unmodified IOS, meaning no trucha,
no ES_Identify etc. If you had any patches applied to IOS prior to
installing DARKCORP v1.0, you have to reapply these patches after
uninstalling.

just in case here is the rest of it.

http://gbatemp.net/t218371-darkcorp-v1-0-release
 

matanga

New Member
OP
Newbie
Joined
Jun 10, 2010
Messages
4
Trophies
0
XP
1
Country
Argentina
I can't install HBC since Hackmii shows "No vulnerable IOS found", nor I can reinstall or uninstall Darkcorp since HBC is not installed in my Wii anymore...

Forgot to mention that I have 4.2U installed.

Any other suggestions?
 

xzxero

♥bong milk does good for the brain♥
Member
Joined
Jul 18, 2008
Messages
3,831
Trophies
0
Age
14
Location
SB
Website
Visit site
XP
332
Country
United States
XFlak said:
Download NUSAD from my signature, run the program, from the main menu, type "H" for Hackmii solutions, follow the prompts, and it will generate a guide for you to follow.

It doesn't get any easier than this.
unless you go to his house and do it yourself.
 

XFlak

Wiitired but still kicking
Member
Joined
Sep 12, 2009
Messages
13,858
Trophies
3
Age
38
Location
Cyprus, originally from Toronto
Website
modmii.github.io
XP
9,856
Country
Cyprus
lol, true very true... if the OP wants to pay for my flight to Argentina, I'll fix his problem personally for free!
biggrin.gif
lol
 

matanga

New Member
OP
Newbie
Joined
Jun 10, 2010
Messages
4
Trophies
0
XP
1
Country
Argentina
LOL, It will be cheaper to send me a new Wii console... I vote for my option!!


I'll try your suggestion and will let you know.

Thanks a lot
 

addy2k

Member
Newcomer
Joined
Oct 8, 2009
Messages
6
Trophies
0
XP
20
Country
Gambia, The
In my opinion the best way would be running the Darkcorp Installer via Bannerbomb and use that to get rid of Darkcorp. If this fails, I would try using DOP-IOS (run via Bannerbomb) to get back to unmodified IOSes 36 and 61. After this is done, HBC should install just fine.
 

Riley

Well-Known Member
Member
Joined
Mar 9, 2009
Messages
1,123
Trophies
0
Location
BC Canada
XP
186
Country
Canada
addy2k said:
In my opinion the best way would be running the Darkcorp Installer via Bannerbomb and use that to get rid of Darkcorp. If this fails, I would try using DOP-IOS (run via Bannerbomb) to get back to unmodified IOSes 36 and 61. After this is done, HBC should install just fine.

Just IOS36. Theres no reason to re-install IOS61 as it wasn't modified in the first place.
 

damysteryman

I am too busy IRL these days...
Member
Joined
Oct 4, 2007
Messages
1,223
Trophies
1
XP
1,026
Country
Antarctica
@Riley
...unless he installed cIOSCORP v3.1 and never uninstalled it (it was removed in v3.2 tough).

@matanga
You had cIOSCORP v3.5 or older installed at some time, right?

Try the cIOSCORP v3.5 Uninstaller. (sorry, I cannot provide a direct link due to teh forum rulez...)

Run it via bannerbomb (copy the "sd:\apps\cIOSCORP_v3.5_Uninstaller\boot.dol" to sd:\boot.dol" in order for it to run from bannerbomb).

Make sure you have cIOS249 installed, as it is needed by the app.

And then you can reinstall DARKCORP if you want. (after performing the uninstall method mentioned above, DARKCORP will then be compatible with hackmii installer)


...and thanks for bringing this issue up. I've now seen that the DARKCORP v1.0 Uninstaller will only uninstall what it modifies, but it doesn't uninstall any pre-v3.6 remnants...

...I'll have to get that fixed.
 

matanga

New Member
OP
Newbie
Joined
Jun 10, 2010
Messages
4
Trophies
0
XP
1
Country
Argentina
The problem here is that I receive the following "exception (dsi) occurred" while trying to run anything from Bannerbomb.

Is there any other way to run DarkCorp uninstaller than by ussing Bannerbomb or HBC?
 

muck chucker

Well-Known Member
Member
Joined
Sep 21, 2008
Messages
161
Trophies
0
XP
52
Country
United States
Try a diffrent bannerbomb from the hackmii website. Also can you give a run down of eveythimg you do from puttin the files on the sd to what you do on the wii.
 

Riley

Well-Known Member
Member
Joined
Mar 9, 2009
Messages
1,123
Trophies
0
Location
BC Canada
XP
186
Country
Canada
Darkcorp DOESN'T install a cIOS61 which is the IOS HBC uses. On the older cioscorps they did have it so it made HBC go upside down. HBC needs the official IOS61 to run on.
 

thesund0g

Well-Known Member
Member
Joined
Aug 6, 2009
Messages
452
Trophies
0
Age
44
Location
The Boonies
Website
Visit site
XP
135
Country
It depends on which IOS the HackMii installer decided to use. Mine was on 36, then I decided to patch it, so I had to uninstall HBC, patch 36, reinstall and it chose 61 that time as it was left unpatched.

Riley said:
Darkcorp DOESN'T install a cIOS61 which is the IOS HBC uses. On the older cioscorps they did have it so it made HBC go upside down. HBC needs the official IOS61 to run on.
 

Site & Scene News

Popular threads in this forum

General chit-chat
Help Users
  • ZeroT21 @ ZeroT21:
    PP is crooked la, set it straight
  • K3Nv2 @ K3Nv2:
    Stop looking at my hooked pp
  • ZeroT21 @ ZeroT21:
    my bad, blame it on lack of lube
  • K3Nv2 @ K3Nv2:
    Barrels of lube
  • ZeroT21 @ ZeroT21:
    still busy hackin' ps4?
  • K3Nv2 @ K3Nv2:
    If the damn script would work it'd be nice
  • ZeroT21 @ ZeroT21:
    maybe it's the incompatible model
  • K3Nv2 @ K3Nv2:
    No it's because I have a arch64 model tv it's just normal ps4 bs
  • ZeroT21 @ ZeroT21:
    yeah, the JB does not activate instantly, because it relies on a flaw showing up in a process
  • ZeroT21 @ ZeroT21:
    I'm on a older 6.72, still kinda tempted to upgrade, maybe a 9.00
  • ZeroT21 @ ZeroT21:
    i probably cant go higher than 9.00 becus i have the CUH-22XX model
  • K3Nv2 @ K3Nv2:
    I keep getting stuck on waiting for padi
  • ZeroT21 @ ZeroT21:
    hmmm, i got no clue, i need to re-check their step by step guide
  • K3Nv2 @ K3Nv2:
    11.0 hack is great if you got a webos tv
  • ZeroT21 @ ZeroT21:
    i dont have LG tvs around
  • ZeroT21 @ ZeroT21:
    all TCL
  • ZeroT21 @ ZeroT21:
    and a sony
  • K3Nv2 @ K3Nv2:
    You can map a button on your remote to launch the script call it a day
  • K3Nv2 @ K3Nv2:
    I'd stay on 9.0
  • K3Nv2 @ K3Nv2:
    I had a spare ps4 on 10.0 so decided to try it
  • ZeroT21 @ ZeroT21:
    i just want to play the psp resistance port
  • K3Nv2 @ K3Nv2:
    Psps are high tech
  • ZeroT21 @ ZeroT21:
    there is no backported version for me fw
    ZeroT21 @ ZeroT21: there is no backported version for me fw