Hacking Boot into ReiNand and back into ReiNand black screen?

[wshinji]

Hi All,

Just completed a CFW of Reinand onto a N3DS running FW 9.0.0.20E

Unlinked NAND running Emunand and Reinand.

Everything works but runs into 2 glitches and was wondering if this was a known issue?

When im in CFW (ReiNand) and I exit but shutting down, then boot back up with HLB and go straight into CFW it goes to a black screen and i need to shutdown to get it back up and running again.
However If i shutdown after its been in CFW and hold L+down to get into sysnand and then go into ReiNand its fine. Just when im in CFW and load CFW again it goes to a black screen. Is that normal?
I havent updated the CFW to latest 11.0.0.33 and im using the default Reinand firmware.bin as the one on the github instantly black screens my CFW and doesnt allow me in if I use the latest github version.

Secondly. If I use menuhax 3.0 and use type 2, it also fails to load CFW. I have to keep with Type 1 in order to successfully boot into CFW assuming the above issue is noted.

Any ideas ???

 

[gudenau]

I would suggest you install arm9LoaderHax.

 

[wshinji]

Does this arm9LoaderHax require me to downgrade to 2.1 firmware from 9.0?

 

[olec04]

Duh unless you wanna do a very precise exploit that's untested and is a hardware exploit

 

[wshinji]

Sorry for my green-ness. just started this last night.
Just checking as Plaulect guide for this is longer than all the stuff ive done since i got the 3DS LOL Seems a lot more complicated than the rest.

 

[olec04]

Its wayyyyy more complicated that. U think