Hey guys, so i did a reflow on the soc to fix a blue screen issue. Unfortunately, when i was screwing down the heat sink the screws didnt tighten at all therefore not holding the heatsink in place.. Is there anyway to fix this?
Hey guys, so i did a reflow on the soc to fix a blue screen issue. Unfortunately, when i was screwing down the heat sink the screws didnt tighten at all therefore not holding the heatsink in place.. Is there anyway to fix this?
What do you mean, reflow?
Thanks for the reply. I did the refow with a heatgun and some flux. No more than 3 mins at about 350c. The blue screen went away and so far its working. Only one screw is really holding the heat sink in place. Can 3 mins of heat cause the board to bow? To me it just feels like the screw hole threading stripped. I will report back if the switch fails.