Hey guys, I have recently tried to replace p13usb since it's the only short on the board (i was getting 0.2 Amp charging then dead). I have accidentally ripped off the pads ( Circled in Red), Is there anywhere I can connect back the trace with a jumper wire? I have also knocked out one of the resistors on the way( Circled in Blue) ( i think its the 100k ohm 0201 ) Thanks
For the bottom red circle, can I connect that to the left side of the missing resistor
P.s. can some one link me the mouser part for the resistor. I have found 3 version with different % , does it matter ? Thanks
For the bottom red circle, can I connect that to the left side of the missing resistor
P.s. can some one link me the mouser part for the resistor. I have found 3 version with different % , does it matter ? Thanks