Hello everybody,
I changed the M92T36 chip and realized after reassembling everything that 2 SMD components popped out.
I did not find them, but have been blown off the desk
They are shown in the red circle in the picture attached.
From the M92T30 datasheet I can see the top one is a capacitor with a non critical value (I put a 100nF replacement one) and the bottom one must be a resistor.
No info on the datasheet so I tried a 10k but I get a bluescreen as soon as I power up.
Can someone use a multimeter and give me the value measured on this resistor (no need to desolder it)? I will guess the right value by comparing with my measurement.
Any help will be greatly appreciated!
I changed the M92T36 chip and realized after reassembling everything that 2 SMD components popped out.
I did not find them, but have been blown off the desk
They are shown in the red circle in the picture attached.
From the M92T30 datasheet I can see the top one is a capacitor with a non critical value (I put a 100nF replacement one) and the bottom one must be a resistor.
No info on the datasheet so I tried a 10k but I get a bluescreen as soon as I power up.
Can someone use a multimeter and give me the value measured on this resistor (no need to desolder it)? I will guess the right value by comparing with my measurement.
Any help will be greatly appreciated!