Of course because you also didn't bother to read the op. But please just insult me for no reason.
Fine, I'll put it politely.
Nobody else is gonna patch everything to work without an SD card just because your Switch is broken. If you want to do that, then I can help if you have any questions.
I didn't expect that. I just asked a question and clearly stated that I can't do it myself. I only asked you because after that you told me that you're the right person to ask. I seriously don't understand what you expect from me. Just to be clear, at this point I don't ask you or any other person to help me. I already got my answer. I don't care about fighting for fightings sake. There is literally no reason to be rude to anyone in this thread. So have a nice day, I'll just wait for that part to arrive.
Read the op next time
Because I broke the reader myself. Had to replace a joycon rail. While putting the Switch back together I must have put too much pressure on the readers ribbon connector. The pins broke off and now I have to wait until the new ones arrives. Thing is tho that I don't know if the connector on the mainboard is broken too. That was the main reason for asking if I could start homebrew from the nand.
I see. Well, if the connector on the board looks okay (pins are intact) and the flap is still working I'd say it's probably fine. Though depending on the connector the pins might be hidden inside. The type with the flap facing the ribbon cable typically have the pins visible but the kind with the flap on the opposite side where you have to push the cable all the way in don't.
The connector on the board looks okay. This one is without a flap. It's one of the small conecctors where you just push down. It's a bit hard to see but I'll include a pic of it.The part marked in red is the part that broke off.
Ah yes, that kind. It's probably more robust than the ones with a flap since that tends to be the weak point. The pins are small and probably fragile though. But if it looks fine it's probably fine. Should be fairly easy to tell if something is broken with that kind of connector.
I had the same issue. After soldering back properly the sd card doesn't work still. Looks like something wrong with motherboard
have you managed to get it working ?
I have founded where to buy the sd card reader module in two weeks a should get it and will ask someone with good soldering skills to replace it. Im hoping that it will fix it
