Hello People , i tried to Mod my Switch Oled , semi successfully but it just wont boot anymore and wont go Past the Nintendo Logo. i noticed after taking it apart (and trying for a Dat0 Adapter that i failed so i just did the Kamikaze method instead), that the console didnt boot past Nintendo Logo and showing me Low Battery icon right after. i thought maybe after all is done it may work again so i kept going with the Picofly. Even after finishing everything and getting the Golden " No SD CARD" i just wont boot to anything . i prepared a working Sd card with hekate (even tried the full HATS zip ) i wont boot into hekate. as soon as it detects the payload its will just show me Black screen. tried just putting in a empty sd card and the picofly would say "no Payload detected". what could have gone wrong here ?? i was thinking about reflowing the emmc but i dont know if that even would make a difference or if my problems even have anything to do with that? Also tried charging it the night but no difference , i even tried it with a known working full battery , still the same .
cause of the bad quality they look missing. I already ordered a new 17050 chip. do you think the smd on the right with the 05 on it needs a replace ? also any tips on how to get the old one of the board without destroying the surrounding ? i have a heatgun suppose to have a 300 celcius mode and a 500 celcius mode, i bought a v1 board just to have some stuff that i could use and i noticed they use the same fuel gauge ic , but i butchered the chip because it wouldnt come off even with 500 celcius , probably also killed it anyway cause of the heat itself,
