Upadating to 13.x, AMS

[Rikua]

Hello! My switch is apparently at 10.x (I'm so lazy with updating lol) and I want to go to 13.x. I know I should use Daybreak when updating, but I had read that there were certain steps I would have to do to make everything work when going to 13.x. Usually I'd just grab the 13.x fw, grab AMS+Sigpatches, replace old AMA+Sig with New AMS+sig, copy over FW files, then run the update. I hate to ask, but can someone please run me through the "extra" steps of going to 13.x? Don't want to brick as I run on Sysnand. Thanks for looking!

 

[Lacius]

Your steps are already fine:

1. Download the latest Atmosphere and put it onto your SD card.
2. Download the latest signature patches and put them onto your SD card.
3. Download 13.0.0 and put it onto your SD card.
4. Download the latest fusee.bin (or Hekate) and use it to launch Atmosphere.
5. Update to 13.0.0 using Daybreak. Make sure you install exFAT support if your SD card is exFAT.

 

[Rikua]

Your steps are already fine:

1. Download the latest Atmosphere and put it onto your SD card.
2. Download the latest signature patches and put them onto your SD card.
3. Download 13.0.0 and put it onto your SD card.
4. Download the latest fusee.bin (or Hekate) and use it to launch Atmosphere.
5. Update to 13.0.0 using Daybreak. Make sure you install exFAT support if your SD card is exFAT.

Are there any folders I should delete before replacing? Such as Atmosphere?
EDIT: Or rename anything like fusee.bin to something else?
EDIT2: Since you didn't specify about the renaming/deleting, I went ahead and made a backup of my AMS stuff, deleted it and the bootloader folders, then replaced it and followed your instructions. Thank you so much, I am now on FW 13 and everything boots from what I can tell!