Switch Oled turn on with hekate, but display is very clear. Resistor damaged?

[Mauroz]

Hi at all, have installed picofly on switch oled and all appare good, but the display is very clear. I tested the A point resistance and it's 4.7 kohms.
In the dat0 point have value low about 470mv with multimeter diodemode. I have tryed 4 different dat0 adapter, but all have the same result, value low about 470mV. I have no SD on display but it is very cleared. Attach the picture. Thank

 

[darkverger]

I suggest you ask on the RetroNX discord, someone might tell you whats wrong if you ask in there.

 

[LuigiGad]

I've never seen such a flaw after a mod, apart from the verticate lines when the video reset is done during startup and shutdown of Horizon. Surely it's a hardware problem, the dat0 I think is ok as a connection otherwise it wouldn't boot hekate. Cross try, remove everything, and also see if I believe you don't fix.