So my switch is unpatched formatted to fat32 this is one that is new to me and I am fixing. It had an issue where little white lines would appear when loading cfw also blue screen when starting. I fixed that (it was the graphics ram) and now as you can see biskeys works normally. And I dumped the keys and they saved to the as card.
when booting normal OS it still blue screens as it did before. When I try to boot hekate the payload succeeds but I get black screen no backlight, same with Linux. Now when I boot fusee I get the issue below in the picture unknown error etc. So a couple things is there a way to check my emmc, and also is there a way to check the firmware version while the switch is off.
should I rebuild the nand?
Any ideas here would be hot
if it was graphics or cpu I assume biskeys would be jacked up like it was before or wouldn’t run and I wouldn’t be able to get rcm.
when booting normal OS it still blue screens as it did before. When I try to boot hekate the payload succeeds but I get black screen no backlight, same with Linux. Now when I boot fusee I get the issue below in the picture unknown error etc. So a couple things is there a way to check my emmc, and also is there a way to check the firmware version while the switch is off.
should I rebuild the nand?
Any ideas here would be hot
if it was graphics or cpu I assume biskeys would be jacked up like it was before or wouldn’t run and I wouldn’t be able to get rcm.
