RP2040 Install clk value ok or not?

[Ragnstoneman]

Hi , I recently got an OLED and decided to mod it (im the kind of person that cant leave things alone and modded every other console ive owned so i thought why not

Before attempting the mod I had read and watched as much info as possible whilst waiting for the rp2040 kit to turn up and also dissasembled and prepped my clk point.

I did the install and checked the values of every point as i I did them. All values came back within range except my clk point which is returning a value of 460. All info i can find says this needs to be over 500. I was careful when revealing the trace and cannot see a break anywhere. Ive attached some images , am i missing something or is a value of 460 ok ?

I did carry on with the install to try it but the switch just reboots continously only displaying the nintendo logo. No lights on the chip were displayed. However im not sure if it was recieving power as the 3.3v pad on the flex cable looks shot after i had to remove and reinstall it. Can i run a wire from them parallel resistors directly to the chip as im pretty sure thats the issue with the power?

Hopefully i can still get this up and running and its not toast

 

[jkyoho]

most likely you have a broken CLK point from the CPU trace to the through hole via.

 

[joaoneves]

Montei o switch inteiro e coloquei o invólucro externo. Eu também verifiquei essa parte USB na parte inferior da placa.

A questão é: seria melhor desmontar o interruptor e colocá-lo no lugar, ou o interruptor ficará bem sem isso?

Essa blindagem protege o USB de curto-circuito ou algo assim, ou é apenas para interferência?