- POST_BUS_1 -> DB3R3
Wiring, Trinity:
- CPU_PLL_BYPASS -> DB2G3 (1-10k safety resistor recommended!)
- POST_BUS_1 -> R3R19
Wiring, Jasper / Falcon:
- CPU_PLL_BYPASS -> DB1F1 (1-10k safety resistor recommended!)
- POST_BUS_1 -> R3P7
Known Jasper/Falcon issues:
- HANA PLL bypass slowdown is not enough for perfect precision,
but HANA PLL reconfig slowdown is unstable. So there are two
files for both ways to try.
- Some consoles crash and never boot because of PLL slowdown, please use RGH2 there
Other known issues:
- Falcon, Jasper & Trinity wiring on retail SMC results in RRoD.
Contacts, PayPal donates: [email protected]
RGH2 to 3 by DrSchottky
Usage: python.exe 2to3.py RGH3_ECC.bin updflash.bin CPUKEY outfile.bin
Known limitations:
- Bad Blocks before Xell (addr 0x70000, blocks 0x0-0x3 on BB, blocks 0x0-0x1B on SB) have to be manually remapped
- Misc
Credits:
- 15432 for RGH3
- build.py creators for ECC code
No, this uses the same principles as RGH, and uses custom bootloaders, so they cannot patch it. JTAG was patched because newer bootloaders were told not to boot 4532 kernel, and you cannot downgrade bootloaders because of fuses, so therefore patched.can this be patched like JTAG since it's chipless? it's basicly JTAG 2.0
BrilliantI'm currently trying it on one of my original Falcon, i'l stuck at the ecc step, how do i boot XELL Reloaded without a modchip ?
UPDATE : One of my solder was bad, and i was writing the ecc as "Retail" and not as" Glitch2". Now everything boot just fine !
UPDATE 2 : Compared it with my first RGH 1.2 XBOX 360 (Falcon) with the same Version (17526), both boot within 8 seconds max. I think we can call it a success x)
possibly, that would be suggestion on fixing it, but there's no guarantee that it's not something else.Hey i would love to try this, but the only 360 o still have turns on but shuts off after about 10 seconds and the light on the power brick turns red. Can i just replace the power brick?
Mine did the same thing after flashing the file with the wrong mode selected. Might be a short-circuit / false-contact on your board, did you checked for any thing that could prevent it from booting ?Hey i would love to try this, but the only 360 o still have turns on but shuts off after about 10 seconds and the light on the power brick turns red. Can i just replace the power brick?
YesI'm a little confused about the Trinity points.. In the Trinity Wiring Pic you can see the SMC_PLL and SMC_POST1 points but not where they goto, The Corona Wiring Pic has both. Do I use the PLL and POST1 points from the Corona Pic?
Thank You, I guessed so but I had to be sure