Replacing the eMMC

[emuman100]

I want to replace my eMMC module in my Mariko V2 because I believe it may be have gone bad. When I got this switch, I made a backup of the BOOT0/1, prod.keys, and eMMC raw GPP. I received a few "replacement eMMC" (probably from damaged Switches).

I restored the BOOT0/1 and raw GPP in Hekate and it was able to boot and I installed a backup. The backup seems to run fine. My question is, is there anything else that needs to be done? Does prod.keys need to be restored? I was looking at some guides, but most seemed to cover restoration of a NAND without a backup.

Thanks.

 

[jkyoho]

boot0/1 and RAWNAND GPP are all you need, prod.key in side the RAWnand

 

[emuman100]

I really appreciate this! So far, everything works quite well. I hope this post is helpful for others!

Thanks again!